Tandberg 3660 Specifications
| Model: Interface: Capacity (formatted): Buffer size: Transfer rate: |
TDC3820 SCSI, SCSI-2 525 MBytes (1,000 ft. tape) 256 KBytes with parity 4.8 MBytes/sec. synchronous SCSI 2.4 MBytes/sec. asynchronous 200 KBytes/sec. sustained |
TDC 3660 SCSI, SCSI-2 250 MBytes (1,000 ft. tape) 64 KBytes with parity 1.4 MBytes/sec burst 90 KBytes/sec. sustained |
| Format and Capacity Write/Read: Write/Read: Read Only: |
QIC-525, 26 tracks, 20,000 frpi, 16,000 bpi (TDC 3820 only) QIC-120/150: 15/18 tracks, 12,500 frpi, 10,000 bpi QIC-24, 9 tracks, 10,000 frpi, 8,000 bpi |
| System Interface Supports SCSI and SCSI-2 Asynchronous and synchronous data transfer Single-ended hardware interfaces |
| Reliability hard read error rate: MTBF: MTTR: |
QIC-525 < 10-11 errors per bit QIC-24/120/150 < 10-11 errors per bit >80,000 hours (TDC 3600), > 120,000 hours (TDC 3820) < 30 minutes |
| Tape Motion Speed read/write: Speed wind/rewind: Speed variation short term: Speed variation long term: Start time: |
QIC-525: 120 ips QIC-24/120/150: 96 ips 120 ips +/- 6% +/- 2% typical 250 ms |
| Dimensions Drive format: Height: Width: Depth: |
5.25" half height 43mm/1.69 inches 149mm/5.87 inches 216 mm/8.51 inches |
| Media Data cartridges: |
TDC 3820: DC 6525 or equivalent TDC 3660: DC 6250 or equivalent |
| Power Requirements +5 V excl. bus terminator (typical): +12 V motor not running (typical): +12 V motor running (typical): Total effect standby (typical): Total effect running (typical): Voltage variations: |
500 mA 50 mA 900 m: 3.1 W 15W +5 V +/- 5% including 100 mV max ripple +12 V +/- 10% including 100 mV max ripple |
| Environmental
Specifications Operating temperature: Storage temperature: Relative humidity: Maximum wet-bulb temperature: Altitude: |
+5° C to +45° C/+41° F to + 113° F -30° C to +60° C/-22° F to + 140° F 20 - 80% operating 10 - 90% transport +26° C/+78° F 4,000 m/13,124 feet operating 13,000 m/42,653 feet storage |
Special Features
- Self-adjusting to variations in media and environmental conditions
- Error correction codes: Read-While-Write and Reed-Solomon Level-2 are implemented
- "Flash" memory for easy change of firmware

